DEBURRING
Deburring services are used to remove imperfections remaining on edges of a laser cut part. The laser creates a very nice edge, but the reality is there is always some kind of "fuzz" or burr on the back side of the part. Our deburring equipment can remove the burr and also soften the edges to make the part safer to handle. Any metal can be deburred - steel, stainless, aluminum, copper, titanium, etc
DEBURRING CAPABILITIES
DEBURRING CAPABILITIES
FLAT DEBURRING
-
Loewer DiscMaster 4TD
-
40" maximum width
-
Equipped with 10" sanding discs and cup brushes that remove the burr and round the edges in one pass
-
Rubber belt allows parts the size of a quarter to be deburred
-
Wide range of discs and grits allows for heavier or lighter deburring as required by the customer
-
Wet dust collector ensures safe collection of mixed metal dust
TUMBLING
-
Mr. Deburr 3.5 cu. ft. wet tumbler
-
For smaller parts that require a uniform finish with aggressively softer edges
-
Ceramic media for steel and stainless
-
Plastic media for aluminum and copper
-
Parts are rinsed after deburring to remove media residue
REQUEST A FREE QUOTE
Fill out the form below and a member of our team will connect with you to discuss your inquiry!